Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| geoscene3d:toolbox:toolbox_grid_operations:grid_order_consistency_check [2020/02/12 20:43] – created rebecca130301_gmail.com | geoscene3d:toolbox:toolbox_grid_operations:grid_order_consistency_check [2020/03/22 19:07] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| The operation does not change any of the grids but produces a problem grid file that indicates where the conditions are not met. If there are no problems the problem grid node value is zero. If there is one problem the problem grid value is 1, and so on. After the problem grid has been created it can be used to locate and solve the problems. | The operation does not change any of the grids but produces a problem grid file that indicates where the conditions are not met. If there are no problems the problem grid node value is zero. If there is one problem the problem grid value is 1, and so on. After the problem grid has been created it can be used to locate and solve the problems. | ||
| - | To actually change one grid based on the conditions use the [[Adjust Grid Difference|]] | + | To actually change one grid based on the conditions use the [[: |
| - | operation. | + | |
| - | __ | + | __Grid |
| - | Grid Files: __ | + | |
| - | The grid files must be organized in the correct order. For 2D grids the grid with the lowest elevation at the bottom of the list and the grid with the highest elevation at the top of the list. Use the Up and Down buttons to organize the grid files. | + | |
| - | ** | + | **Settings ** \\ |
| - | Settings ** \\ | + | __Min Difference: |
| - | __Min Difference: | + | __Max Difference: |
| - | Minimum distance in elevation or node value \\ | + | __Output Grid Same Size As:__ The output grid will have the same geometry as the grid selected here. |
| - | __Max Difference: | + | |
| - | Maximum distance in elevation or node value \\ | + | |
| - | __Output Grid Same Size As:__ | + | |
| - | The output grid will have the same geometry as the grid selected here. | + | |