Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| geoscene3d:profiles_and_regions:top_plot [2021/07/29 11:50] – [Step 3. Edit Top Plot] rj | geoscene3d:profiles_and_regions:top_plot [2021/07/29 13:55] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Top Plot ====== | ====== Top Plot ====== | ||
| - | This tutorial contains a video and a written guide how to make and use a top plot from multiple datas. This tutorial operates with pre-made profiles, | + | This tutorial contains a video and a written guide how to make and use a top plot from multiple datas. This tutorial operates with pre-made profiles, |
| {{vimeo> | {{vimeo> | ||
| Line 11: | Line 11: | ||
| ---- | ---- | ||
| - | ==== Step 2. ShowTop | + | |
| + | ==== Step 2. Show Top Plot and add a surface ==== | ||
| 1. Right clik profile in " | 1. Right clik profile in " | ||
| Line 28: | Line 29: | ||
| {{: | {{: | ||
| - | |||
| ==== Step 3. Add points toTop Plot ==== | ==== Step 3. Add points toTop Plot ==== | ||
| - | * Note the small blue boxes fixed to the boreholes | + | * Note the small blue boxes on top of the 1D models |
| 1. Repeat step 2.2. just rightclick the XYZ points in Object Manager and check if the point values are listed on the left side axis. | 1. Repeat step 2.2. just rightclick the XYZ points in Object Manager and check if the point values are listed on the left side axis. | ||
| Line 53: | Line 53: | ||
| ==== Step 4. Results ==== | ==== Step 4. Results ==== | ||
| - | * Lastly, the terrain curve can be clicked back to the profile observed as the red line and a green isopach grid curve (.grd) can be activated to the Top Plot that demonstrates | + | * Lastly, the terrain curve can be clicked back to the profile observed as the red line and a green isopach grid curve (.grd) can be activated to the Top Plot. The green curve is the thickness of the orange layer in the profile. The layer thicknesses can be read on the right side axis. |
| {{: | {{: | ||