Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tutorials:adddata:vms [2020/01/14 14:58] – [Step 2. Add a WMS layers] gs3d | tutorials:adddata:vms [2020/03/25 11:08] (current) – removed gs3d | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Add WMS layers from GEUS ====== | ||
| - | |||
| - | This tutorial will show how to add WMS layers from GEUS. | ||
| - | |||
| - | ==== Requirements ==== | ||
| - | |||
| - | === Module === | ||
| - | |||
| - | FIXME | ||
| - | |||
| - | === Data === | ||
| - | |||
| - | |||
| - | ==== Step 1. Select data at GEUS ==== | ||
| - | |||
| - | \\ | ||
| - | 1.Visit the GEUS website and select the interactive map, or copy the following address:\\ | ||
| - | \\ | ||
| - | [[http:// | ||
| - | \\ | ||
| - | In the bottom right corner there is a drop down menu where other cards can be selected. Select the map " | ||
| - | \\ | ||
| - | [[https:// | ||
| - | |||
| - | {{: | ||
| - | <font inherit/ | ||
| - | |||
| - | |||
| - | ==== Step 2. Add a WMS layers ==== | ||
| - | |||
| - | 1. Press the "Add new map layer " button {{: | ||
| - | \\ | ||
| - | 2. Check on the "Web Service (WMS/ | ||
| - | {{: | ||
| - | \\ | ||
| - | 3. Press the " | ||
| - | \\ | ||
| - | 4. Copy the link from GEUS website into the ”Web Service URL” and select “Web Map Service (WMS)” under the Web Service Type.\\ | ||
| - | {{: | ||
| - | \\ | ||
| - | 5. Press the ”Next” button to go to the " | ||
| - | \\ | ||
| - | 6. Press ”Finish” and the data should be added to GeoScene3D. | ||
| - | |||
| - | TIP: Make sure the map section is as minimal as possible, this will shorten the loading time. If there are problems loading the WMS, then check what the projection is set to. It must be 25832. | ||
| - | |||
| - | |||
| - | ==== Step 3. Open the WMS data ==== | ||
| - | |||
| - | 1. Open the ”Layer Manager”, by pressing the “Map properties and layer manager” button | ||
| - | 2. The “Layer Manager” will show you all the WMS layers you have added from GEUS and the desired parameters can be clicked on and off. | ||
| - | |||
| - | ==== Step 4. Result ==== | ||
| - | |||
| - | 1.A legend can be downloaded from the GEUS website.\\ | ||
| - | 2. Water types are shown on the map and the legend for the water types are downloaded as a picture.\\ | ||
| - | |||